Kuwait University

Low Level Sulfur Analyzer

The principle for the operation of sulfur analysis begins with the complete, high temperature oxidation of the entire sample matrix. The sample is combusted with oxygen at a temperature of 1050 ºC. The combustion gases are routed through a membrane drying system to remove all water and then to the sulfur detector module for quantization. The SO2 is exposed to ultraviolet radiation of a specific wavelength. This radiation is re-released in the form of sulfur fluorescence. The fluorescence is detected by a photomultiplier tube (PMT) and it is proportional to the amount of sulfur in the original sample.


  • Petrochemicals.
  • Ultra low sulfur content fuel.
  • Pharmaceutical Industry.
  • Green Manufacturing.

Specification and standards:

  • ASTM D7183 - 07e1
  • Sulfur detection range 1…25 ppm

Manufacturer and Model No.
Manufacturer: Antek by PAC instrumentation
Model No.: Multitek

Location: Bldg No. 8Kh, 208
Contact: Ext. 3621